MT Fluid Change

[Accorduke]

Hey Im not normally the one to ask for help but i need help with my MT fluid how do I check it? and well I found out that you dont put fluid in the little black plug be the headers on my 93 F22a anyway why is the plug there and where do i look to measure my fluid and add more?

i normally go to SoundCo in Tulsa for all my fluid changes they do it fast and use high quality crap but i am going to do it my self now!

so any help would be good help

[vic92accord]

Go to tha master cylinder pop off tha top n check how low it is. Mt fluid is basically brake fluid. If its low u will notice thats where u add n check. As far as i know u have to drain ur brake fluid to change it. I had a problem wit my master cylinder and it caused my tranny to not shift n my clutch was very loose and when i checked tha brakefluid it was gone so i added more and bam my clutch n shiftin was normal again so i would check that. if u have ne more questions let me know laterz.

[vic92accord]

o and i dunno bout tha black plug :D

[93-LX-C]

o and i dunno bout tha black plug :D

I think what your talking about is the fluid for the clutch. What Accorduke is talking about it the fluid that is actually in the transmission which is two different things. There are two plugs located on the passenger side i believe, I never did it on my f22 tranny but have on my h22 tranny, and the one on the bottom is just like the oil drain plug once removed the fluid will be drained out of the tranny. Then on my h22 tranny there is another plug above the drain bolt that i used to fill it back up. There are also two plugs on the side that you use a socket wrench to remove, they're square, and those are used to check the levels in the tranny which i don't know how to do.

[vic92accord]

there ya go i didnt even know that so now i know thanx dood

[Accorduke]

to check the level of the tranny fluid you simply take you finger and stick it in and if you pull it out with tranny fluid on it then your good but no tranny fluid then add sum till you get you fingers wet :)


Nice sounding

[Accorduke]

the plugs are located behind the front wheel on the passenger side


there are all ratchet ends

I belive hondsa says to use 10w 40 for MT and decron 2 or 3 for AT