f22 to h22??!?!?!

[Infini Omega]

ok this kid is trying to put an h22 manual trans into an f22 auto which mounts does he use?

[jdmaccordbo!916]

did this post get redone over or something.. i swear thatit was already posted by you a few days ago, an i replied to it.... dam dajavu

[AccordTunr333]

He has to get the conversion mount for the tranny side of things first, HASport said they make one now i think. But motor mounts wise, go h22a where you can cause they are stiffer but the front mount i don't think will fit into an accord.

-Garrett

[Infini Omega]

thank you accordtuner

[AccordTunr333]

thank you accordtuner
Hold up now, I'm not done yet:

Getting the H22 bolted in will require cutting, tweaking and general rearrangement of the stock left-side mount, or the purchase of Hasport's part for this swap. He'll have to use the softer Accord front mount because the stiffer Prelude mount is the wrong height--bummer, however energy suspension makes bushing inserts for accord mounts that he might wanna invest in (they're only a couple of bucks). Either the Accord or the Prelude rear bracket and mount set (no mixing and matching between them) can be used, but the Prelude parts are stiffer and a wiser choice. If the car started as an automatic, you'll need to weld in a manual transmission bracket (Honda P/N 60831-SV4-970ZZ) to the right side frame rail in place of the automatic part. Or just put the project on hold until January 2004, when Hasport produces a mount that will adapt the auto's frame rail bracket to a manual transmission.

hehe ;) that should get him on his way!

-Garrett